Creating Ped

[manve1]

I have problem when i create a ped, it disappears after like 1 second, how can i change this?

[myonlake]

Wrong interior or dimension I assume.

[Tomc0]

Can we see your script..?

[manve1]

addEventHandler('onResourceStart', getResourceRootElement(), 
    function() 
        ped1 = createPed( 87, -285, 1206, 74 ) 
        setElementDimension( ped1, 1 ) 
        setElementAlpha( ped1, 255 ) 
    end 
) 

i need it in dimension 1

[Tomc0]

And are you sure you are at this dimension?

[manve1]

YES! fuckin hell ... when i restart it, it appears then it disappears after 1sec

[Smart.]

Try to freeze it and see what happens or higher your Z position because it may be too low causing the ped to fall down

EDIT: You sure the interior is correct? (setElementInterior)

[manve1]

thats only freezing, but its not moving, but it just disappears

[Smart.]

thats only freezing, but its not moving, but it just disappears

Err.. and that's the full script?

[myonlake]

No need for an event nor alpha set. Also make sure you are in dimension one and if it's a map, I suggest adding some decimals to the z-coordinate so it lands on the map as it loads - or freeze the ped.

local ped1 = createPed(87, -285, 1206, 74) 
setElementDimension(ped1, 1) 

Edited November 1, 2012 by Guest

[manve1]

guys, i found it out .. thx for help ( nothing helped, just other problem )

[Renkon]

Why don't you write what was the problem so we prevent people from having the same problem?

[manve1]

the problem was that it landed on roof of interior