setDevelopmentMode

[Gtagasje]

Hi, I was trying to make a gate move with a colshape, since I did it always with markers.

I wanted to see where my colshape was, because it was not at the place where the gate is.

So I tried this command which I found in another post about this: "/crun setDevelopmentMode(true)" but I didn't get any message, and when I type after that command this ingame: "/showcol" or "/showcol 1" I get this in my console: "showcol set to 1, but this will not have any effect because development mode is off."

And yes, I have read the wiki already, so just coppieing from the wiki won't help me.

Thanks in advance.

Gtagasje.

[Evil-Cod3r]

show the code if you have and we well help you with it

[Gtagasje]

I made this in like 1 minute, but it might be full off fault's.

  
function setmode () 
    setDevelopmentMode(true) 
end 
addEventHandler("onClientPlayerJoin", getRootElement(), setmode) 
  

It is client.

And I have this in my meta:

  
client="1.1.1-9.03355" server=""/> 
  

[Zango]

onClientPlayerJoin wiki page:

It is triggered for all players except the local player

use onClientResourceStart attached to resourceRoot

also, for crun (client variation of run) to work, you need to start the resource `runcode`

[Gtagasje]

Ok, i'll try that.

Edit: It works! Thank you very much!

Edited February 21, 2012 by Guest

[Evil-Cod3r]

remove this on the meta

and keep this